Monday, September 28, 2009

Pedestal Table continued



Thought I had better put a picture of the pedestal in to better explain the shape. This is actually mounted on the lathe and then turned "upright" for a better view.
I said before that there were four beads. Actually there are only three - one and a half on top and one and a half near the bottom. The top beads were made a little smaller to give a better proportional look.
If you look closely you can see a tenon near the bottom which will be used to mount a small finish saucer which should cover the bottoms of the legs and spindle.

No comments:

Post a Comment